10th Symposium of Agronomy

10th International Scientific Conference on Agricultural Development and Sustainability

10th Symposium of Agronomy

EVALUATION OF DIFFERENT AGAM PROPAGATION METHODS AND PLANTING TECHNOLOGIES IN THE PRODUCTION OF CATEGORIZED SUGAR CANE SEEDS IN CUBA

Abstract

The results of two studies in areas of the Registered Seed Bank of the Ciudad Caracas Sugar Company in the province of Cienfuegos are presented, where two methods of agamic propagation (Cuttings and Vitroplants) and two planting technologies (distance between rows at 1 .50 m and 1.80 m), the cultivar used was C10-166, the evaluation was carried out at 11 months of age. The area of the plots of the experiment with traditional technology was 60 m2 and that of the Wide Base was 72 m2. The variables studied were t cane ha-1, stem length (cm), stem diameter (cm) and number of stems m-1, as well as the economic value of propagation by cuttings comparing both planting technologies. The randomized block design with three repetitions was used, simple variance analysis and mean comparison test were performed using the Multiple Range test with Tukey's test (p<0.01 and p<0.05), in addition regressions were performed, of first and third order to determine the variables with the greatest influence on agricultural performance. The results obtained were significant increases in the variables number of stem m-1 and t cane ha-1 in favor of propagation by vitroplants, the broad-based planting technology surpassed the traditional one in stem production and agricultural yield, the number of stems m-1 linear had a positive and significant relationship with sugarcane production and the Benefit/Cost relationship was positive.

Resumen

Se presentan los resultados de dos estudios en áreas del Banco de Semilla Registrado de la Empresa Agroindustrial Azucarera Ciudad Caracas de la provincia de Cienfuegos donde se evaluaron dos métodos de propagación agámica (Esquejes y Vitroplantas) y dos tecnologías de plantación (distancia entre surcos a 1,50 m y 1,80 m), el cultivar empleado fue la C10-166, la evaluación se realizó a los 11 meses de edad. El área de las parcelas del   experimento con tecnología tradicional   fue de 60 m2 y el de Base ancha fue de 72 m2. Las variables estudiadas fueron, t caña ha-1, longitud de los tallos (cm), diámetro de los tallos (cm) y número de tallos m-1 así como la valoración económica en la propagación por esquejes comparando ambas  tecnologías de plantación.  Se empleó el diseño de bloque al azar con tres repeticiones, se realizaron análisis de varianza simple y  prueba de comparación de medias mediante prueba Múltiple de Rango con dócima de Tukey (p<0,01 y p<0,05), además se efectuaron regresiones de primer y tercer orden para determinar las variables de mayor  influencia en el rendimiento agrícola. Se obtuvo como resultados  incrementos significativos en las variables número de tallo m-1 y t caña ha-1 a favor de la propagación por vitroplantas, la tecnología  de plantación de base ancha superó a la  tradicional en la producción de tallos y el rendimiento agrícola, el número de tallos m-1 lineal tuvo una relación positiva y significativa con la producción de caña y la relación Beneficio/Costofue positiva.

About The Speaker

Samuel Cortez Figueroa

Samuel Cortez Figueroa

INICA Matanzas Flag of Cuba

Discussion

Practical Info
Presentation
Spanish / Español
November 13, 2023 4:50 PM
10 minutes
Salón 1 Starfish
Authors
Samuel Cortez Figueroa
Keywords
caña de azúcar.
métodos de propagación
planting technologies
propagation methods
sugar cane.
tecnologías de plantación
Documents